WorkBee How To Connect A Software Emergency Stop Button

Image	Instructions
	Wire the Emergency Stop into the Extruder 1 Stop input on the controller. The two wires go into the outside pins, leaving the middle empty. Polarity is not a concern.

Image	Instructions
	This will configure a Normally Closed Emergency Stop. For a Normally Open Stop proceed to Step 3. Under File Management > System click on 'config-user-settings.g'. Then add the following lines ; Configure Software Emergency Stop M950 J1 C"!e1stop" ; Configure Pin M581 P1 T0 S0 ; Configure External Emergency Stop M582 T0 ; Check External Trigger Press Save. Press the software emergency stop in the top right corner to restart the controller.

Image	Instructions
	This will configure a Normally Open Emergency Stop. Under File Management > System click on 'config-user-settings.g'. Then add the following lines ; Configure Software Emergency Stop M950 J1 C"e1stop" ; Configure Pin M581 P1 T0 S0 ; Configure External Emergency Stop M582 T0 ; Check External Trigger Press Save. Press the software emergency stop in the top right corner to restart the controller.

¶ Step 1: Wiring