 |
- The two outside Extrusion-C's should be spaced 80mm in from the end of the Extrusion-A's.
- Once in position, check they are square with the Extrusion-A's, then tighten all the M5-Button-Head-Bolt-8mm on these two Extrusion-C's.
|
 |
- The central two Extrusion-C's should be spaced evenly so the 3 gaps are of equal size.
- Once in position, check they are square with the Extrusion-A's, then tighten all the M5-Button-Head-Bolt-8mm on these two Extrusion-C's.
|
 |
- To double-check the base is square, measure the diagonals. They should be the same.
- Adjust if needed.
|
